Skip to content
JNDRO Wall-Mounted Space Heater with Thermostat and Remote Control

JNDRO Wall-Mounted Space Heater with Thermostat and Remote Control

By JNDRO · Space Heaters · Home & Workspace

Compare all Space Heaters side by side →

  • 1500W PTC ceramic heating element
  • 120V standard household power
  • 41°F to 95°F thermostat range
  • 16.5 inches wide, 4.65 inches deep
  • Wall mount with included hardware

Price not listed

New
More on eBay (1)
Used, refurbished, open-box

Stores with a price are sorted lowest first; commission never changes the order. Prices are snapshots. Check the current price with the store.

JNDRO Wall-Mounted Space Heater with …View at JNDRO

Summary

The JNDRO Wall-Mounted Space Heater is a compact plug-in PTC ceramic heater for a 120 V outlet, with a 41–95 °F thermostat, three heat levels, a 24-hour timer and a full-function remote. Check the listing revision and buy only if the 12-month warranty and documented features matter more than independently measured performance, which is unavailable for this exact model.

Strengths

  • The wall mount keeps floor space clear and the 4.65-inch depth suits above-furniture placement.
  • The remote carries every unit function, including heat level, ECO, oscillation, timer, child lock and mute.
  • The 41–95 °F thermostat and 24-hour timer give finer control than a simple fixed-heat panel.
  • ETL certification, overheat protection, a flame-retardant housing and a child lock cover the basics.
  • ECO mode modulates output instead of holding full power continuously.

Weaknesses

  • No instrumented test of this exact wall unit was found from an established review outlet.
  • No exact-model owner reports, forum threads or retailer Q&A were located.
  • JNDRO’s own praise pages are generalised across the range, not traceable owner accounts.
  • Per-level wattage for the three heat levels is not published, so output per setting is unclear.
  • The 200 sq ft coverage claim depends on insulation, ceiling height, drafts and outdoor temperature.
  • JNDRO has less established brand support than major heater manufacturers, and no spare-parts catalogue or repair documentation was found.

Verified specifications

ModelJNDRO Wall-Mounted Space Heater with Thermostat and Remote Control, 16.5-inch wall format.
Dimensions16.5 in wide × 4.65 in deep; weight not published for this model.
Heating elementPTC ceramic, rated 1500 W, twelve heating plates behind the outlet with a fan drawing air across them.
Power1500 W maximum, 120 V standard household outlet, plug-in with no hard wiring.
Thermostat range41 °F to 95 °F on an LED display, with an ECO calibration step.
Heat modesthree heat levels plus fan-only.
Oscillation60°, 90° or 120°.
Timer24-hour timer.
Controlstouch controls on the unit plus a remote that duplicates every function.
ECO moderegulates output; the LED display switches off after 30 seconds of inactivity.
DisplayLED.
Safetyoverheat protection, flame-retardant housing, child lock, ETL certification.
Warranty12 months from date of original purchase.
Room coverageabout 200 sq ft as stated by the manufacturer.
Useindoor only; an open carport, covered patio or leaky shed is not suitable.
Remote batteriesremote is included, but its two AAA batteries are not.
Full research notes and sources

Controls and installation

JNDRO documents this as a plug-in unit for a standard 120 V outlet, so mounting needs no electrician. The brand says the wall mount uses supplied hardware, but it does not publish a load rating, stud or anchor requirements, or a permitted mounting height. General wall-heater guidance suggests mounting 18 to 24 inches from the floor so the thermostat reads accurately.

The thermostat runs from 41 °F to 95 °F and can be calibrated against an HVAC sensor by pressing the timer button for five seconds in ECO mode. The remote handles heat level, fan-only, ECO, oscillation angle, timer, temperature unit, child lock and mute. The brand describes the thermostat as cycling the element and ECO as regulating output, so real draw is normally below 1.5 kW continuous. No measured duty cycle is published.

Running costs and electrical load

At the 1500 W maximum, the heater draws about 1.5 kWh per hour, roughly 5,118 BTU/h and about 12.5 amps at 120 V. BestSpaceHeater puts one full-power hour at about $0.23 at $0.15/kWh and about $0.30 at $0.20/kWh, while thermostat cycling and ECO mode reduce actual consumption. A dedicated circuit is recommended for 1500 W models so other high-power devices do not trip the breaker.

Plug the heater directly into a wall outlet pushed fully in. Keep combustibles at least three feet away, and turn the heater off when sleeping or leaving the area. JNDRO calls for a dry indoor space and a dust-free outlet and plug.

Evidence and warranty

The feature set is documented by the manufacturer, but independent evidence is thin. JNDRO is absent from the specialist wall-heater roundup. Noise level, warm-up time, thermostat accuracy and real-world heat distribution remain untested.

The warranty covers 12 months from the date of original purchase, and the brand says its support team responds within 24 hours. Manuals include troubleshooting and customer-care sections, but no manual PDF, spec sheet or spare-parts catalogue was found on either first-party site.

Which model this is

This is the compact 16.5-inch JNDRO wall-mounted heater, not the wider 22.8-inch wall model or any JNDRO portable heater. The listing identifier is ASIN B0FJDD8ZSS. No separate manufacturer part number was published on the brand pages read.

Sources

Manufacturer:

Independent reviews:

Buying guides for this category

Related products