ANYCUBIC Water-Wash Resin 2.0: problems, parts and running costs
Checked: 2026-10-26
Summary
Owners and reviewers report that this water-washable resin can be brittle, with prints shattering after curing or breaking at thin sections, and that the 8K-labelled variant is smelly and ships without printed settings. Keeping it running means buying more resin at $25.99 on sale ($35.99 regular) per kilogram plus water or 95% IPA for washing. At that price it suits detailed display pieces and miniatures, with the 8K-specific detail best realized on 4K, 8K and 12K printers.
Common problems and fixes
- Brittleness and shattering after curing — owner reports describe prints that feel solid, then shatter after a day or so, with miniature ankles breaking when dropped and rafts cracking when scraped from the build plate; over-curing increases brittleness and a 2-3 minute cure is described as the sweet spot. [8][9][4][6]
- Conflicting wash and cure instructions — the product page says to clean in a wash and cure machine for about 10 minutes using at least 95% alcohol or cleaner, then dry and secondary-cure for 3-5 minutes, while the spec sheet lists IPA for at least 3 minutes or water for at least 5 minutes and post-curing of at least 3 minutes. [1][5]
Parts and consumables
No replaceable parts or consumables reported.
Other consumables: the resin itself and cleaning agents (water or 95% IPA), plus washing and curing equipment; wastewater must not be drained to sewers and should be UV-cured before disposal. [1][5][6]
Yearly running cost
Not enough data. The sources give a per-kilogram price ($25.99 sale / $35.99 regular at the ANYCUBIC store, October 2026) and cleaning costs in water or 95% IPA, but no typical annual print volume or usage rate, so a yearly total cannot be computed. [1]
When it is a good buy
- The 2.0 formula’s lower brittleness and anti-yellowing over 6 weeks justify use for detailed display pieces and miniatures; the 8K-labelled variant’s sharper detail (readable 0.6 mm text) is best realized on 4K, 8K and 12K printers, and on 2K printers the 8K-specific benefits are not fully realized. [4][6]
- ABS-like resin is the better choice when toughness matters, since water-washable resins remain more brittle than ABS-like resins. [5][6]
- Phrozen Aqua Ivory is the better choice when FEP sticking matters, based on one owner finding this resin sticks to FEP more than that resin. [5]